Wiring help!!!

[Blackout_03]

OK...I am just about dont installing my Zez kit. I bought the cup holder switch pak. Where do I need to wire up the 12v power wire to? Can i just tap into the acc port in the console? or do i need to find a better place under the dash? Thanks I did a search but didnt realy find what I was looking for.

[05 S281]

is this source going to be powering the solenoids directly, or is it going to be powering a relay that in turn powers the solenoids? If it were me and it were going to be powering the solenoids directly, I would wire it directly to the battery with an inline fuse. If the power were going to a relay that provides closes a circuit, i would wire it to the acc port and have no worries. The Solonoids will draw more power than a relay will.

[sweet2kstang]

there are 2 actuall accessory wires under the dash. i would either run the power side strait off the battery or hook up to the accessory wire under the dash. a wire off a lighter or something could power it, but was never made to. the wire could get hot and cause issue later. i trying to find my wire diagram from directtech, but i will get under the mach in a little bit if i cant find it.

[Blackout_03]

The wire will come from the EMU[zex box] and go to the cup holder.....then the cup holder has a power wire that need a 12v power. So yes it will power the box. I think Im going to just wire it right to the battery...that way when I hook up the purge and heater there will be plenty of power. Thanks!

http://www.americanmuscle.com/3poniswawapu.html

http://lib.store.yahoo.net/lib/mustangtuning/OceanNSProfile