Machining ???

[backfocus]

I need to get the inlet of my GT40 upper take resurfaced a little bit. Does anyone know a local machine shop they trust and can do it and not have wait 2 months. I had my block done by Rebel Rebuilders, but it took 8 months. Intake is aluminum by the way.

In Missouri some auto parts store, such as Oriellys did small stuff like this, but I have not found any around here that do. Heck the guy at Advanced Auto wouldn't even order me a part I wanted for my wife Toyota, because he said they would have to mark it up, I didn't care, because I needed it, still wouldn't order it. Idiots!

[oxman]

We use a place called Delta Wells screening in NLR. At work we have him special make things,thread things, he even rebuilt our trailer and did an awesome job! He is very good and fast. I don't have his number, it's at my work but I'll get it for you tomorrow. He gives us excellent prices to boot! ;)

[stumbaugh]

the best machine shop around arkansas is in scranton. I think the name is Rogers Garage. One of my really good friends works there, his name is Cody Rogers. I will try and get the shop number, just tell him Jake Stumbaugh sent u, he will hook you up.

[backfocus]

Thanks John, I couldn't find that place in the phone book, so I will be awaiting the number.

Also a thanks too Jake, but that place is a little too far, it would probably involve taking off 2 days to do that.

The place I used for my motor did a great job, but it is only 2 guys and they are always covered up. I called them back about this and they said it would probably be 2 months before they could get to it.

[oxman]

ok, it's 982-4795 ask for Charles. Tell him John at HD supply told you to call. let me know how it goes.